Advanced users • Re: RPI Secure boot not working as expected

After enabling UART in config.txt like below , please below logs.

enable_uart=1
eeprom_write_protect=1
program_pubkey=1

Logs :-

[ 0.039244] Serial: AMBA PL011 UART driver
[ 1.312360] Serial: 8250/16550 driver, 1 ports, IRQ sharing enabled
[ 1.920719] usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
[ 1.920887] usb usb1: SerialNumber: 0000:01:00.0
[ 1.922187] usb usb2: New USB device strings: Mfr=3, Product=2, SerialNumber=1
[ 1.922395] usb usb2: SerialNumber: 0000:01:00.0
[ 2.017073] uart-pl011 fe201000.serial: there is not valid maps for state default
[ 2.019592] uart-pl011 fe201000.serial: cts_event_workaround enabled
[ 2.021990] fe201000.serial: ttyAMA1 at MMIO 0xfe201000 (irq = 36, base_baud = 0) is a PL011 rev2
[ 2.024358] serial serial0: tty port ttyAMA1 registered
[ 2.027952] bcm2835-aux-uart fe215040.serial: there is not valid maps for state default
[ 2.033457] fe215040.serial: ttyS0 at MMIO 0xfe215040 (irq = 37, base_baud = 62500000) is a 16550
[ 3.927674] usb 1-1: New USB device strings: Mfr=0, Product=1, SerialNumber=0
[ 9.361192] systemd[1]: Created slice system-serial\x2dgetty.slice - Slice /system/serial-getty.
[ 13.382436] hci_uart_bcm serial0-0: supply vbat not found, using dummy regulator
[ 13.384449] hci_uart_bcm serial0-0: supply vddio not found, using dummy regulator
[ 13.505189] uart-pl011 fe201000.serial: no DMA platform data

If there any other logs , let me know the same.

Statistics: Posted by Nitishthakur306 — Sun Jul 28, 2024 3:10 pm

---