When using a standard Pi your options are either designing a HAT for mounting ontop of the Pi, or designing a 'baseboard' where you attach the Pi somehow. In both cases you will be limited to your GPIO40 connector.
Doing a custom baseboard for CM5 should be the way to go. Gives you full freedom to add what you require on the board geomertry that you need.
Use the CM5IO kicad project as your starting point
Doing a custom baseboard for CM5 should be the way to go. Gives you full freedom to add what you require on the board geomertry that you need.
Use the CM5IO kicad project as your starting point
Statistics: Posted by aBUGSworstnightmare — Wed Feb 19, 2025 5:28 am